Program settings

1. Download the ZIP file by clicking the Drive link above and extract it.
2. Run the wchisptoll_setup.exe file after installation, select "RISC-V”
3. file - load ui config - “venom_60_he” Select

1. CHECK “automatic download when device connect”
2. Press ... in the object file to select 60HE_7U.

PCB Settings

1. Prepare the PCB. Work on top of the PCB packaging plastic (static cling) to prevent static electricity.

1. Touch digits 7 and 8 with tweezers, then press the Reset button.

1. This is a close-up of the 7 and 8 spots for the tweezers.

1. Touch pins 7 and 8 with tweezers and press the reset button.

1. Of the two buttons, the one on the left is the reset button.

1. After installing the firmware, press the reset button and the red LED on the caplock will light up for about a minute. If you unplug the cable at this time, you can start over from the beginning.

1. When the firmware switch is complete, the white light will illuminate as shown below.

Working with VENOM.HOW after connecting

Connect to VENOM.HOW , connect the PCB and run a factory reset from the Settings tab.

If the PCB is not recognized, start over with the program settings.

How to Update the Firmware

Access VENOM.HOW and connect your keyboard. Enter the 5th tab, "Settings" and click on Update Firmware.

After selecting the version, tap Enter Bootloader - Connect Device - Start Update to proceed with the update.

When the update is complete, you're returned to the Key mapping screen.